HB120-S Dry Bath Incubator

Description:

HB120-S exact metal bath for heating small containers can be connected to an external

temperature sensor PT1000 precise control of sample temperature. Heating block replacement is simple,

a variety of optional specifications for different sizes of tubes, centrifuge tubes, the PCR tube, 96 well plate,

widely used in the field of molecular biology, histology, clinical testing, environmental science and chemical analysis.

The constant humidity metal bath can be widely used in the incubation, boiling, deactivation, wet digestion,

sample concentration and enzymatic analysis preservation and reaction of samples of various analytical instruments,

DNA amplification and pre-denaturation of electrophoresis, serum coagulation, etc. The industry covers medicine,

chemical industry, food safety, quality inspection, environment, etc.

Features:

1.A wide range of temperature control up to 120°C;

2.Timer function support is available;

3. Various types of optional blocks are available;

4.Overheating protection;

5.Lid for protection and heat preservation;

In order to ensure the stability and stability of the constant temperature metal bath in use, the user

should pay attention to the following operations:

1. In the process of setting a new temperature, the system still operates according to the last set temperature value,

until the number stops flashing in the LCD window.

2. Before and after each use, the cone hole of the module must be cleaned with a cotton swab dipped in distilled

water to ensure that the test tube is in full contact with the cone hole wall.

3. If it is used in the experiment operation at a constant temperature of 4°C for more than 4 hours, the condensed

water of the module must be removed. The method is: unplug the power plug to cut off the power supply, then unscrew

the two black knobs on the module, take out the module, remove the condensed water on each contact surface with a soft cloth,

and then install and reset the module.

4. If the difference between the displayed temperature and the third-party measured temperature is more than 0.1℃,

the custodian of the machine will correct the temperature error.

5. During use, it is forbidden to press the key.

It does not have the shortcomings of traditional dry thermostats such as large temperature fluctuations, easy pollution,

and troublesome temperature control. It is a good substitute for traditional water bath devices. In addition, the daily maintenance

of the equipment should be done well in the use of constant temperature metal baths. In particular the following:

1. The surface needs to be scrubbed frequently to keep it clean. When scrubbing, the side of the instrument control box should be

avoided to avoid water dripping into the instrument and damaging the instrument.

2. When not in use for a long time, especially in the rainy or humid season, it should be powered on and run for 5-8 hours regularly

to drive off the moisture absorbed by the electrical components of the equipment.

3. An appropriate amount of grease should be added every few months, and the fuse box, control components and fastening screws

of the instrument should be checked regularly for looseness.

<IMG src=”//sc04.alicdn.com/kf/H109f8df1f31d46e3a08e3bf3e735c606h/234470787/H109f8df1f31d46e3a08e3bf3e735c606h.jpg” class=”magic-34″/>